Abstract
<jats:p>Fluorescence imaging in the second near-infrared window (NIR-II, 950-1700 nm) offers reduced scattering, lower autofluorescence, and deeper tissue penetration than NIR-I imaging, but its adoption is limited by the need for custom-synthesized fluorophores. Here, we identify commercially available dyes that exhibit usable NIR-II emission. Eleven visible, far-red, and NIR-I fluorophores were screened under twelve acquisition configurations combining 670, 760, and 808 nm excitation with band-pass (950 nm, 1400 nm) or long-pass (1000 nm, 1250 nm) emission filters. Output varied markedly with fluorophore identity and excitation/emission configuration. Among hydrophobic dyes, DiR exhibited strong emission across almost all excitation and emission filters. Among hydrophilic dyes, strong NIR-II fluorescence was observed for IRDye 680RD (excitation at 670 nm), sulfo-cyanine 7 (excitation at 670 nm and 760 nm), and indocyanine green (excitation at 808 nm). DiR showed a linear concentration-response under 760 nm excitation with BP1400 detection. Upon encapsulation in PEGylated liposomes, strong NIR-II fluorescence was retained. In an in vivo study in mice, NIR-II resolved vasculature that NIR-I could not consistently delineate, and enabled pharmacokinetic analysis. Both windows returned similar ex vivo organ distributions. NIR-II imaging is therefore accessible using commercial off-the-shelf fluorophores, provided the dye is matched to the intended excitation/emission configuration.</jats:p>