Abstract
<jats:p>Введение. Строительство и эксплуатация линейных объектов предусматривает наличие специальной охранной зоны или зоны отчуждения, в которой производится вырубка древесно-кустарниковой растительности. После расчистки охранных зон в течение 4…5 лет происходит интенсивное зарастание за счет лесовозобновления быстрорастущими лиственными породами. Существуют различные решения по снижению темпов лесовозобновления на территории охранных зон. Например, обработка химическими препаратами. Но такая обработка дает лишь кратковременный эффект из-за быстрого снижения концентрации препаратов из-за осадков. Цель исследования– разработка научно обоснованных технологий снижения интенсивности лесовозобновления на территории, тяготеющей к охраняемым линейным объектам (ЛЭП, трубопроводы) на основе применения древесно-минеральных смесей. Задачи – обосновать целесообразность и разработать практическое решение утилизации неликвидной древесины, древесных отходов в плане возможности ее внесения в виде защитной мульчирующей посыпки территории, прилегающей к линейным объектам; изучить биотехнологические и агролесоэкологические вопросы влияния наличия древесно-минерального материала на отзывчивость и скорость роста древесных и кустарниковых растений; изучить влияние способа внесения смеси, толщины слоя и процентного соотношения компонентов древесно-минерального материала на интенсивность лесовосстановления. Объектом исследования является технология защиты охранной зоны линейных объектов от нежелательной древесной и кустарниковой растительности. Методы исследования: анализ литературных и патентных источников по теме работы, эксперименты. Результаты. Обоснована хорошая перспектива практического применения внесения грунтово-древесно-минерального композита для снижения темпов роста нежелательной древесно-кустарниковой растительности. Предложена технология очистки полосы отчуждения линейного объекта в виде измельчения древесно-кустарниковой растительности на дробленку самоходным мульчером и добавления в мульчу минерального вяжущего (жидкого стекла и кремнефтористиго натрия) с введением в рецептуру водного раствора арборицидов. Выводы. Защитные зоны линейных объектов требуют постоянного внимания в плане их очистки от нежелательной древесно-кустарниковой растительности. Сочетание технологии мульчирования самоходными мульчерами и внесения измельченной древесной дробленки в виде древесно-грунто-минерального композита с растворами арборицидов на основе жидкого стекла и кремнефтористого натрия позволяет покрывать территорию охранной зоны линейного объекта защитным слоем, имеющим прогнозируемый срок разрушения под действием естественных природных условий. Наличие древесно-минерального материала негативно сказывается на темпах лесовозобновления, снижает скорость роста древесных и кустарниковых растений, что позволяет существенно снизить трудозатраты и издержки на проведение мероприятий по расчистке территорий защитных зон линейных объектов.</jats:p> <jats:p>Introduction. The construction and operation of linear infrastructure facilities require the establishment of special protective zones or buffer zones where tree and shrub vegetation is cleared. Following the clearance of these protective zones, intensive regrowth occurs within 4–5 years due to reforestation by fast-growing deciduous species. Various approaches exist to reduce the rate of reforestation within protective zones, such as chemical treatment. However, such treatment provides only a short-term effect due to the rapid depletion of active compounds caused by precipitation. The research aims to develop scientifically substantiated technologies for reducing the intensity of reforestation in areas adjacent to protected linear facilities (power transmission lines, pipelines) through the application of wood–mineral mixtures. The study seeks to justify the feasibility and develop a practical solution for utilizing non-commercial timber and wood waste as a protective mulching layer applied to areas adjacent to linear facilities; investigate biotechnological and agroforestry aspects related to the influence of wood–mineral material on the responsiveness and growth rate of tree and shrub species; and examine the effect of mixture application method, layer thickness, and component ratio of wood–mineral material on reforestation intensity. The focus of the study is the technology for protecting the buffer zones of linear facilities from undesirable tree and shrub vegetation. Materials and methods. The study employs analysis of scientific and patent literature and experimental investigations. Research outcomes. The high potential of applying soil-wood-mineral composite to suppress the growth rate of undesirable tree and shrub vegetation is substantiated. A technology for clearing linear facility buffer zones is proposed, involving the shredding of tree and shrub vegetation using a self-propelled mulcher, followed by the addition of a mineral binder (liquid glass and sodium silicofluoride) to the mulch, together with an aqueous arboricide solution incorporated into the formulation. Conclusions. The protective zones of linear facilities require continuous maintenance to control undesirable tree and shrub vegetation. Combining mulching technology using self-propelled mulchers with the application of shredded wood chips in the form of a wood–soil–mineral composite incorporating arboricide solutions based on liquid glass and sodium silicofluoride enables the formation of a protective layer over the buffer zone with a predictable degradation period under natural environmental conditions. The presence of wood–mineral material adversely affects reforestation rates and reduces the growth rate of tree and shrub species, thereby significantly decreasing labor and operational costs associated with vegetation clearance in protective zones of linear infrastructure facilities.</jats:p>